Eathernet data Transfer (example)

1. SERIAL DATA PROTOCOL
• The I/P data should be serial one bit data.
• The Preamble data 10101010 should be matched and when it is
matched store the 16 bit data.
• Make the Ready signal High When the first 8 bit is stored.
• Send the first 8 bit data parallel to the O/ P.
• When the first 8 bit is received then the Rx sends an ACK signal.
• After receiving ACK signal ready signal should go down.
• When the lower 8 bit data is ready send again ready signal high
send data to the O/P port.
• Wait for ACK signal.
• If ACK signal signal does not come within 7 clock cycle ERROR signal
make high.
• And the device goes back to IDLE state.

2. TOP LEVEL MODULE
S_in
Dout parallel
ACK
Clock
Ready
Reset

3. Clock signal flow graph
clk
rst
din
SHift_en
Shift_Reg
Ready
Ack
dout
error

4. TOP LEVEL INTERNAL MODULE
Shift REGISTER SIPO
S_in Dout parallel
8 bit
TD_En SD_En
Clock
AKW
STATE MACHINE
Ready
Reset

5. STATE MACHINE(Description)
• The state machine diagram is used to detect
the Preamble Data.
• The Preamble data Format is 10101010.
• As it detect the Header Data it Enable the Shift
register for next 16 bit.
• At the same time as the register is 8 bit long.
• For the Synchronization of 8 bit data to output
there is one more counter which enable the
TX_Data signal High as the 8 bit is stored.

6. STATE MACHINE(cont…)
• When the data transfer is complete it again go
to the next state to check the Header Data
format.
• Thus the state machine moves from one state
to another until the next header is detected.
• Complete:

7. STATE MACHINE DIAGRAM
reset
Din== X
idle 0
1
0
TD_En=1’b1 0 s1
count !=16
Ready=1’b1 S8
1
SD_En=1’b1
1
1 s2
0
S7 0
0 0
1
S6 s3
0 1 1
1
S5 S4
0

8. SHIFT REGISTER
• The shift register should shift the 16 bit data.
• When the data is shifted send the 8 bit data to
O/P.
• When the data is Received Rx should send
ACK signal then shift register transfer its
another 8 bit data to the output.
• The output data should be 8 bit parallel in
nature.

9. SHIFT REGISTER
Sin
Sequential
Block Combo
clk Block
Dout
SD_En
TD_En
reset

10. TEST BENCH
• The test bench should generate the clock and
reset signal.
• The transfer of data should go the top
module goes serially.
• The transfer of data take place at each clock
edge.
• On receiving the 8 bit data send the ACK
signal.
• Test the top module.